







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Roofing: The Glendale Owner’s Guide
Replacing failed Unilock roof components in Glendale usually runs $400 – $1,800 for a targeted repair or $8,000 – $20,000 for a full roof replacement, and we can often schedule an inspection within the same week. Most owners don’t discover the problem until a ceiling stain appears after the first winter rain, or they notice grit from the shingle surface collecting in the gutter downspout. Unilock has been an independent roofing materials manufacturer since the 1970s, and their products appear on a meaningful share of Glendale’s 1970s and 1980s housing stock. When a component fails, it rarely announces itself. It leaks quietly, then all at once. We’re Rowan Construction Group Glendale, and we install Unilock-compatible roofing under the Haven Standard: a written flat price before any work starts, a documented photo record on every visit, and the 365-Day Done Right Promise. We are an independent service provider and not affiliated with Unilock.
Which Unilock Models This Applies To

Unilock roofing material compatibility is the part most homeowners skip, and it’s the part that causes the most expensive mistakes. Unilock’s roofing lines have changed specs several times since their 1970s peak production era, and a “matching” shingle from a different manufacturing run may have a different exposure width, a different tab pattern, or a different sealant strip. If you’re patching a repair, the part has to match your existing run, not just the brand name.
Here’s how to identify what you have: pull a single shingle from a corner or a ridge and check the underside for the printed manufacturing code, which carries the series number and production date. Measure the exposure width (the visible face of each course) from the butt of one shingle to the butt of the next. That measurement, not the packaging, tells you which series you’re working with. Common Unilock-era exposures sit at either 5 inches or 5-5/8 inches, and the two aren’t interchangeable on a repair.
The OEM-versus-aftermarket decision depends on the scope. For a single-tab repair on a roof that has 8 or more years of service life left, a close aftermarket match is honest work and usually fine. For anything within 3 feet of a valley, ridge, or penetration, the sealant chemistry matters and we source the closest OEM-spec equivalent we can find. If the roof is more than two-thirds through its lifespan, patching becomes throwing good money after bad. We source roofing material across GAF and Owens Corning as well as Unilock-compatible stock, and we also handle KraftMaid, Cambria, and Silestone for other systems on the same property. We claim no stock of parts and no parts carried on a truck. What we bring is verification and a written number.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Roofing Is Failing
- Grit in the gutters after rain. The mineral surface of an aging Unilock shingle sheds as the asphalt beneath it cracks and oxidizes. Once shedding starts, the shingle’s UV protection is gone and the clock is running on the whole field.
- Curling or clawing tab edges. Tabs lift because the sealant strip has released. In Glendale’s inland-heat cycles (summer afternoons pushing 95°F to 105°F, then cooler nights), that thermal expansion and contraction opens seams that held fine for a decade.
- Dark streaks or moss on the south face. Those streaks are usually algae feeding on trapped moisture near the shingle’s limestone filler. On north Glendale roofs shaded by trees, moss is the signal that moisture is sitting where it shouldn’t be.
- Ceiling stains or attic dampness after rain. A water stain on the ceiling isn’t a shingle problem anymore; it’s a flashing or underlayment failure that the shingle was masking. Once the deck has been wet long enough to show a stain, the wood beneath may already be compromised.
- Visible hail dents or granule scars after a storm. Glendale sees hail in late winter and early spring. Fresh impact marks on the shingle face are a signal to document the damage on a photo record before the next storm makes it harder to attribute.
Replacement Cost & What’s Included
| Scope in Glendale | Installed Price |
|---|---|
| Targeted roof repair (flashing, tabs, penetration) | $400 – $1,800 |
| Tile roof repair | $600 – $2,500 |
| Partial replacement (one slope or section) | Quoted after inspection |
| Full roof replacement | $8,000 – $20,000 |
| Metal roof installation | $15,000 – $40,000 |
The range is driven by square footage, pitch, layer count (the number of existing shingle layers that have to come off), and whether the deck needs repair once the shingles are up. A steep roof in the Verdugo foothills costs more in labor than a low-slope roof in south Glendale, and that’s a real number in the quote, not an excuse. Our written price includes the materials, the labor, the tear-off and disposal, and the written workmanship warranty. There’s no “call for a quote” step. The flat price is written down before anyone starts, and under Clause 1 of the Haven Standard, no change proceeds without a signed change order.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Roof work is genuinely dangerous, and we say that plainly. A single-story pitch can still put you on a ladder in the heat, and a two-story roof in Glendale with an afternoon wind is a place a fall happens fast. That’s the honest safety caveat, not scare tactics.
What an owner can safely check from the ground: binoculars on the shingle field to spot curling or missing tabs; the gutters for granule deposit; the attic for daylight or dampness; and the ceiling for stains after rain. What goes wrong with DIY is the actual repair, because pulling a tab to “take a look” breaks the seal on the adjacent shingles, and re-sealing is a specific chemistry, not a tube of caulk. We have up to 19 years of experience on our technicians, and we do this every week. Call (844) 320-5930 for a free estimate.
FAQs

Most Unilock shingle roofs in Glendale last 15 to 25 years with normal maintenance, with the lower end driven by south-facing sun exposure and the upper end on shaded north slopes. The limiting factor is the sealant strip, not the mineral surface, and the inland heat cycles accelerate that failure. Call (844) 320-5930 for an inspection and a written assessment of where your roof sits.
Yes, if the damage is localized and the shingle field has meaningful service life left. A flashing repair or a limited tab replacement in Glendale can often be done within the $400 – $1,800 repair range. If more than two-thirds of the roof is at end of life, patching is honest work on a roof that won’t last another season, and we’ll tell you that. Call (844) 320-5930 for a free second opinion on any written estimate you already have.
A targeted repair is usually done in a single visit. A full roof replacement on a typical Glendale home runs 2 to 5 days depending on square footage, pitch, and how many layers come off. We give you the schedule in writing with the price. Call (844) 320-5930 for a written scope and timeline.
We identify your series and exposure width from the manufacturing code on an existing shingle, then match it against OEM-spec stock or a verified equivalent, and we confirm the match with you before ordering. We claim no parts stock of our own, and we put the sourcing decision in the written scope so you know exactly what’s going onto your roof. Call (844) 320-5930 for a free estimate.
What Happens When You Call
We send a background-checked, uniformed technician who documents what we find on a photo record you keep, including the shingle condition, the deck condition where visible, and any flashing or underlayment problems. You get a written flat price and a written scope before anyone picks up a tool, and you can compare it against any other quote with our free second opinion review. The call is answered by a live person, 24/7. Call (844) 320-5930 to schedule your free estimate for Unilock-compatible roofing in Glendale.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












