







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Home Additions & ADU: The Glendale Owner’s Guide
We build Tamko-compatible home additions and ADUs in Glendale at a typical installed cost of $45,000 to $130,000 for an addition and $90,000 to $220,000 for a full ADU, with a written flat price before any work starts. These aren’t next-day jobs, and we won’t pretend otherwise: plan on a scheduled start and a construction timeline set in your signed scope. Owners usually find the problem the same way. A Tamko underlayment or flashing detail on the addition roof starts to lift at a seam after a rainy season. Water stains appear on a new ceiling. Or a room never quite holds temperature because the tie-in to the main house was never closed out properly. We’re an independent contractor, not affiliated with Tamko; we work with its roof and building-envelope materials every week.
Which Tamko Models This Applies To

Tamko doesn’t make a single “ADU part.” What it makes is the roof and weatherproofing system that sits over your addition or accessory dwelling unit: shingles, underlayment, and flashing accessories. Glendale additions most often use Tamko’s Heritage line of laminated architectural shingles (often the Heritage and Heritage Pro profiles) and Tamko’s MetalWorks steel shingles where a low slope or a modern look is wanted. Underlayment matters as much as the shingle, and Tamko’s synthetic underlayments are the layer that actually stops a leak when a nail pops or a seal fails.
To match the right material, read the bundle wrapper or the Tamko label on a leftover shingle and note the printed product name, then measure a shingle tab (laminated architectural tabs typically run in the 12- to 13-inch range with 5- to 6-inch exposure, and an average bundle carries roughly 33 square feet). That measured exposure tells us which profile you have so we order the correct matching material or a compatible equivalent. On the OEM-versus-aftermarket question: matching the original Tamko profile keeps your color and warranty story clean, while a quality equivalent can save money on a repair. We price both, in writing, and you choose.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Home Additions & ADU Is Failing
- Granules in the gutter or at the downspout. A steady loss of granules means the shingle surface is wearing and its UV protection is going. It’s the first visible sign of age on a Tamko roof, before a leak ever shows.
- Curling or lifted shingle tabs at the addition roofline. Heat and sun exposure at a low-slope or south-facing section cause edges to lift, and once a seal breaks, wind gets under the shingle. This is common on Glendale additions where the new roof meets the main house.
- Stains or bubbling on a new interior ceiling. A ceiling that bleeds brown rings after rain points to a failed flashing or underlayment at a valley, chimney, or wall tie-in, not the open field of the roof.
- Caulk and sealant pulling away at the wall-to-roof joint. The line where the addition connects to the existing house moves with the seasons; when the sealant cracks, water gets behind the siding.
- A room that never holds its temperature. On an ADU or addition, a cold or hot room often traces to an unfinished insulation or air-seal detail at the tie-in, not the shingle itself. We open it up and document what we find.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

On the additions and ADU side, the number that matters in Glendale is the project scope. A home addition runs $45,000 to $130,000, a full ADU $90,000 to $220,000, and a garage conversion $30,000 to $80,000. The range is set by square footage, foundation and structural work, roof pitch and materials, electrical and plumbing tie-ins, and how the finished space blends into the existing house. If the job is a repair to a failed detail rather than a new build, a roof repair runs $400 to $1,800 and a roof replacement $8,000 to $20,000.
You get a flat written price with a written scope, so the materials, labor, and warranty are all itemized. No change proceeds until the change order is signed, which is how we keep projects within a few percent of the agreed number. Every visit includes a documented photo record, and every job carries the 365-Day Done Right Promise.
DIY or Call Us?
You can safely do a few things yourself: note the Tamko product name off the label, snap a photo of lifting tabs or granules in the gutter, and check your insurance and warranty paperwork. Where it goes wrong is the roof surface and the tie-in details. Climbing an addition roof to reseal flashing or reset shingles is a fall risk, and a wrong underlayment or flashing repair traps water that shows up months later on a ceiling inside. Refinishing and enclosure work can also touch electrical and structural connections that a permitted job must get right. If your addition or ADU has a failing envelope detail, call us at (844) 320-5930 and we’ll schedule a free estimate. We’ll bring the Free Second Opinion on any written estimate you already have, reviewed line by line at no charge.
FAQs

How long should a Tamko roof on an addition or ADU last in Glendale? A properly installed Tamko architectural shingle roof typically gives 20 to 30 years in Southern California; sun exposure and ventilation are the biggest factors in how close to that window you land. Tamko’s material warranty is separate from installation, so the parts-plus-labor warranty we write into your scope is what covers the work. Call (844) 320-5930 for a free estimate.
Can the material be repaired instead of replaced? Yes, if the failure is isolated to a flashing, a valley, or a handful of shingles. A local repair runs $400 to $1,800 and often solves a single leak. If the whole field is granule-starved or the underlayment is gone, a repair only delays a replacement. Call (844) 320-5930 for an exact quote; estimates are free.
How long does a swap take? A focused repair or flashing replacement is often a day or two once scheduled. A full roof replacement on an addition or ADU typically runs one to three days depending on size and pitch, and the wider addition or ADU build is a scheduled, multi-week project, not a same-day job. Call (844) 320-5930 to get your timeline in writing.
How do you source the Tamko part? We match the printed Tamko product name and the measured shingle exposure to order the correct OEM profile or a quality equivalent, and we price both options in writing so you can compare. For adjoining finishes we also handle KraftMaid, Cambria, and Silestone. Call (844) 320-5930 to start a free estimate.
If you’re planning an addition or ADU in Glendale, or your existing one has a failing roof or tie-in detail, we’ll put the price in writing before anyone picks up a tool. A written flat price, a signed change order for any change, background-checked crews, and a documented photo record on every visit all come standard. Call Rowan Construction Group Glendale at (844) 320-5930 to schedule your free estimate.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












