







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambridge Pavers Home Additions & ADU: The Glendale Owner’s Guide
Cambridge Pavers doesn’t make the structure of an addition or an ADU. It makes the paving that finishes one: driveway aprons, walkways, patios, and the hardscape that ties a new square footage onto an existing Glendale house. The “parts” on an addition are the pavers, edging, base, and joint system underfoot, and those are what fail first. Whether you’re adding a primary suite or building a full ADU, the paver surface is the interface between an existing lot and new construction. We install Cambridge Pavers-compatible additions and ADUs across Glendale, and the paver portions of a project typically land between $7,000 and $18,000 on the driveway side, $3,500 and $11,000 on the patio side, sitting inside a total home addition run of $45,000 to $130,000 or an ADU at $90,000 to $220,000.
Owners usually discover a problem not from the structure but from the ground: a paver course lifting against a new stem wall, efflorescence whitening a joint line, or a settled apron pulling away from a garage. That’s the failing part. The addition itself is fine. The connection is not.
Key Takeaways
- Cambridge Pavers supplies the hardscape, not the framing; the “part” to replace is pavers, edging, base, or joint sand.
- Glendale’s clay-heavy soils and dry summers create specific settling patterns we plan around before an addition is framed.
- A DIY pull-and-relay on a couple of pavers is reasonable; redoing a course against a new foundation is not.
- Rowan Construction Group Glendale is an independent contractor, not affiliated with Cambridge Pavers.
Which Cambridge Pavers Models This Applies To

Cambridge Pavers lines the trade knows well: Ledgestone, Maytrx (yes, spelled that way), Olde English Wall, and the Cambridge Pavingstones family more broadly. Each has its own thickness and face profile, and each sets the tolerances for an addition. Ledgestone runs roughly 2 3/8 inches thick; Maytrx is designed for heavier pedestrian loads and is deeper. When a retrofit happens against a new addition’s stem wall, a mismatched thickness creates a visible step at the doorway, and that step is the first thing an inspector notices.
To identify what you have, look at three things before anyone quotes: paver thickness at a pulled edge (measure at the actual course, not the label), the joint width (Cambridge profiles typically want 1/16 to 1/8 inch), and whether the existing bed is a sand-set or a base-set. Sand-set pavers behave differently against new concrete than a base-set course does.
The OEM-versus-aftermarket decision is honest here. Cambridge Pavers’ own replacement units are the clean spec match, and for a wall or a visible apron that’s usually the right call. For a driveway apron or a back patio, a quality aftermarket paver from Belgard or Techo-Bloc (both in Rowan’s fifty-plus brand catalog) in a matched color can work and cost less. What we don’t do is tell you they’re interchangeable when the joint profile says otherwise. Rowan Construction Group Glendale is an independent contractor; we source and install, and our written quote names the brand and the spec line by line.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cambridge Pavers Home Additions & ADU Is Failing
- A paver course lifting or heaving against the new stem wall. That’s almost always moisture trapped under the base course against fresh concrete, and it reads as a joint problem but is really a drainage problem.
- Efflorescence that returns after every rain. The white mineral bloom is coming from within the base material, not the paver face. If it reappears within weeks of cleaning, the subgrade is the culprit.
- Depression at the garage apron or a doorway threshold. In Glendale, we see this most where the addition brought new grading loads onto an old driveway. The apron settled; the framing is fine.
- Joint sand washing out faster than it should. Cambridge pavers want polymeric joint sand; if the previous install used plain sand and the slope is under 1.5 percent, it will wash out within a couple of seasons.
- Edging migration at the patio perimeter. The plastic or aluminum edge has shifted, and pavers are spreading. Left alone, the outer course is the next to fail.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

The installed price range for the paver portion of a Cambridge Pavers project in Glendale lands between $45,000 and $130,000 on a full home addition, and between $90,000 and $220,000 on an ADU. Inside that, the paver line items run like this:
- Paver driveway installation (addition apron or full redo): $7,000 to $18,000
- Paver patio installation (new addition footprint): $3,500 to $11,000
- Driveway replacement (if the apron forces the whole run): $5,000 to $14,000
- Driveway sealing (post-project protection): $250 to $700
What drives the range is base depth, the amount of existing paver to be lifted and re-laid, and whether an edging and drainage retrofit is needed. We don’t carry parts on a truck, and we don’t claim to. What we do: quote a flat written price with the paver brand, thickness, and base spec named line by line, and back the work with the 365-Day Done Right Promise. Under Clause 1 of The Haven Standard, the number is written before anyone starts.
DIY or Call Us?
An owner can safely pull one paver, look at the base, and photograph the joint. That much is reasonable, and it helps when you call. What goes wrong is the next step: relaying a course against a new foundation without resetting the base, or patching joint sand over a moisture problem. Both look fixed for a season, then fail under the first winter rain.
If you’re looking at a paver that’s heaved against your new addition or an ADU threshold that’s settled, that’s a base-and-grading question, not a paver question, and it’s worth a professional look. We bring background-checked, uniformed technicians, and every visit includes a documented photo record of what we found. If you already have a written estimate from another contractor, we’ll review it line by line free of charge as a second opinion. Call (844) 320-5930 to schedule a free estimate.
FAQs

A properly installed Cambridge Pavingstones surface with polymeric joint sand and a six-inch compacted base should hold its geometry for 25 to 30 years in Glendale’s climate, where dry summers and the occasional heavy rain season do more damage to joints than the pavers themselves. The paver face will outlast the joint and the edging, which is why we spec those two carefully. Call (844) 320-5930 if you want an honest read on what’s under an existing surface.
Yes, in most cases. A single course or a localized settling zone can be pulled, the base re-compacted, and the pavers re-laid, which costs a fraction of a full replacement. What can’t be repaired cheaply is a joint system that’s failed uniformly across a patio, or edging that’s migrated at every corner. Call (844) 320-5930 and we’ll tell you which one you have.
A localized paver pull-and-relay around an addition or ADU typically runs one to two days; a full driveway replacement on top of a new addition runs two to four days depending on base depth and drainage. We schedule around your household, not the other way. Call (844) 320-5930 for a scheduling window.
We identify the specific Cambridge Pavers line (Ledgestone, Maytrx, Olde English Wall, or another) from the existing unit’s thickness and face profile, then source the matching unit through our brand relationships. Rowan’s catalog runs fifty-plus vetted brands including Cambridge Pavers, Belgard, and Techo-Bloc, plus KraftMaid, Cambria, and Silestone for interiors, which means the written quote has real numbers, not padded ones. Call (844) 320-5930 to start a free estimate.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












