







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Driveway & Pavers: The Glendale Owner’s Guide
We install Cambria-compatible driveway and paver systems across Glendale, and paver driveway installation typically runs $7,000 – $18,000 depending on square footage, base depth, and edge restraint. If you already have a Cambria hardscape product that’s failing, the fix is often a targeted repair or partial tear-out rather than a full replacement. Both are quoted in writing before a shovel moves.
Owners usually find out the hard way. A paver lifts at a corner after the first big rain of the season. Sand starts washing out of the joints onto the sidewalk every time it drizzles. One section sits a half-inch proud of the rest, and the car pulls slightly when you roll over it. In Glendale, where clay-heavy soil sits under a lot of the older lots and summer heat bakes the surface for weeks, these failures show up faster than homeowners expect. We see it most on driveways over 10 years old that were never re-sanded.
Which Cambria Models This Applies To

Cambria’s hardscape line covers interlocking concrete pavers, permeable systems, and large-format slabs, sold through dealer programs rather than direct. So the first job is figuring out exactly which product and series you have before anyone quotes a replacement. The easiest way to identify it is to check the original install paperwork, or look for a manufacturer stamp on the back or side edge of a loose paver. Measure the face dimensions – many lines run 4×8-inch or 6×9-inch nominal, but not all, and the joints are sized to the series, not just the paver.
The compatibility gotcha on Cambria pavers is base thickness. The published spec for most residential paver driveways calls for a compacted aggregate base of 4 to 6 inches plus bedding sand, and if the original install ran shallow, a like-for-like paver swap won’t fix the problem. You’ll be back in the same spot within two seasons. We measure base depth during the site assessment, not by eyeballing it.
On the OEM-versus-aftermarket question: Cambria pavers matched to the same series give you a true color and dimension match, which matters if you’re repairing a section rather than tearing out the whole driveway. Quality aftermarket equivalents (Belgard and Techo-Bloc both make compatible systems) can work and often cost less, but the color will not match an existing Cambria field, and the edge profile may not interlock cleanly with what’s there. Rowan Construction Group Glendale is an independent contractor and is not affiliated with Cambria.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cambria Driveway & Pavers Is Failing
- Sand washing out of joints. Rain and irrigation carry joint sand down through the paver layer when the sand has degraded or was never topped off. Once the joints open up, pavers shift against each other and the surface gets uneven.
- Pavers lifting or rocking at the edges. Edge restraint that wasn’t set in concrete, or that cracked, lets the field spread outward. When that happens the whole edge zone moves and the pavers pop free.
- Standing water after storms. Poor slope or a settled base traps water in low spots. Left alone, that water works under the pavers and softens the base for good.
- Color fading or efflorescence. A white chalky film (efflorescence, a salt migration to the surface) is often cosmetic but signals moisture movement through the slab. It’s common in Glendale’s hot stretches when the surface dries fast and the underside doesn’t.
- Cracks in the pavers themselves. Cracks mean too much load on a base that can’t carry it, or pavers installed over a concrete slab that’s failed underneath. Both need diagnosis before any paver gets swapped.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what a Cambria-compatible driveway or paver job runs in Glendale, all in writing before work starts:
| Work | Installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Driveway replacement | $5,000 – $14,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway sealing | $250 – $700 |
The range is driven by square footage, base depth and repair needs, edge restraint type, and whether the old surface has to be demolished and hauled. Our quotes separate material, labor, demo, and haul-off so you can see where the money goes – and under Clause 1 of The Haven Standard, the flat price is written before anyone picks up a tool. No change proceeds without a signed change order. Workmanship is backed by our 365-Day Done Right Promise.
DIY or Call Us?
Re-sanding joints, sweeping, and topping off a driveway sealer and cleaning efflorescence are all reasonable owner projects – those are maintenance, not installation. Where DIY goes wrong is base work and edge restraint. A paver driveway that fails usually fails underneath, and you can’t diagnose a shallow base or soft spot by looking at the surface. Tearing up pavers by hand and resetting them over a bad base just buries the same problem again.
There’s nothing about this work that’s dangerous the way a live electrical panel is, but there is one real hazard: lifting and stacking pavers that weigh 20 pounds or more, hundreds of them, is a back injury waiting to happen. And an unstable driveway under a car is its own problem. If you’re seeing movement or pooling water, call us for a site assessment. Call (844) 320-5930 to schedule a free estimate.
FAQs

A properly installed paver driveway runs 25 to 50 years, but the base and edge restraint do more to determine that than the paver itself. In Glendale, we see installs in the 10-to-15-year range showing joint sand loss and edge movement that shortens the practical lifespan.
Yes, often. Localized repair – lifting a section, fixing the base, re-sanding, resetting – is common and far cheaper than a full tear-out if the failure is confined. If more than a third of the field is moving or the base is soft throughout, replacement is the honest call. Call (844) 320-5930 for a site assessment.
A localized repair is typically a one-day job, weather permitting. A full driveway replacement usually runs several days depending on square footage, demo, base prep, and cure time for the edge restraint. We give you a written timeline with the quote.
We identify the series from the install paperwork or an exposed paver edge, then source the matched series through a dealer or specify a compatible quality equivalent if an exact match isn’t available. We tell you upfront where the cost and match trade-offs land.
We also work with KraftMaid, Silestone, and Kohler on the interior side, so if a hardscape project turns into something bigger, you’re not starting the search over. Call (844) 320-5930 for a free estimate, and bring any competitor’s written quote if you have one – our free second opinion reviews it line by line at no charge.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












