







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Roofing: The Glendale Owner’s Guide
IKO is one of the largest shingle manufacturers in North America, and its products are common on Glendale roofs – particularly its architectural lines and its synthetic underlayments. A typical IKO roof replacement in Glendale runs $8,000 to $20,000 installed, while a targeted repair runs $400 to $1,800. We install and repair IKO-compatible roofing across Glendale and the surrounding hillside neighborhoods.
Most Glendale owners don’t know they have an IKO roof until something fails. The discovery usually happens one of two ways: a water stain appears on a ceiling during the first big rain of the season, or a roofer who came out for a gutter cleaning hands over a photo of curled, cracked shingles and asks how old the roof is. Our technicians have up to 19 years of experience reading exactly those signs on Glendale roofs.
Key Takeaways:
- IKO shingles are common across Glendale; the part that usually fails first is the sealed tab, the flashing, or the synthetic underlayment – not the whole roof.
- Installed repair: $400 – $1,800. Full replacement: $8,000 – $20,000 in Glendale.
- The written price comes before any work starts – flat scope, flat number.
- Documented photo record on every visit is standard, not an upgrade.
Which IKO Models This Applies To

IKO’s residential lineup is built around a few families you’ll see on Glendale roofs. The Cambridge and Cambridge Cool lines are architectural laminated shingles sold in standard bundles. The Dynasty series is a heavier, thicker architectural shingle. The Marathon line is a three-tab. On the flat and low-slope side, IKO’s Armourglass is a common mineral-surfaced roll roofing, and the company’s synthetic underlayment is often sold under the Stormtite name.
To identify what you have, check three places: the original bundle wrapper if the previous roofer left one in the garage or attic, the manufacturer’s label tucked inside the ridge vent, and – most reliably – the physical shingle. Cambridge and Dynasty shingles have a laminated two-layer construction with a visible sealant strip running horizontally across the tab; three-tab shingles have deep notches at every tab break. Measure a single tab: standard IKO tabs are nominal 12 inches wide and 5 to 5 5/8 inches tall depending on series, and getting the series right matters because sealing strips and nail-zone positions differ between product families. Install a Dynasty over a Cambridge-pattern nail line and you’ll miss the nailing zone entirely, which voids the manufacturer’s wind warranty.
Rowan Construction Group Glendale is an independent service provider – we’re not affiliated with IKO. That independence is useful: we can match you to genuine IKO product when the warranty or color match requires it, or recommend a comparable high-quality aftermarket shingle from another manufacturer when it makes more sense for the budget. We source through 50-plus vetted brands including GAF and Owens Corning, plus KraftMaid cabinets, Cambria and Silestone countertops on the interior side.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Roofing Is Failing
IKO architectural shingles have a rated service life that typically runs 25 to 30 years for three-tab and 30 to 50 for architectural – but in Glendale’s conditions, real-world lifespan often comes in shorter. Afternoon sun load, the Santa Ana wind events each fall, and the thermal cycling between 50°F nights and 95°F afternoons all stress the shingle mat and the sealant strip faster than the spec sheet assumes. Here’s what to look for:
- Curled or lifted tabs. The sealant strip has failed, usually from repeated heating and cooling cycles. This is the most common IKO failure we see on Glendale roofs facing west or south.
- Granules in the gutters. A little is normal – a lot means the shingle’s protective surface layer is breaking down. Check the rate: a handful of grit per downspout per season is fine, but a coffee can of granules after one storm means the asphalt sheet is close to failing.
- Cracked or split tabs. Usually from thermal shock – an unusually hot day followed by a cool marine-layer evening. Small splits spread quickly once water gets in.
- Water staining on the ceiling or in the attic. The shingle surface may look fine from the ground; the failure is usually at a penetration, valley, or 90-degree wall flashing where the shingle meets the vertical surface.
- Moss, dark streaks, or blistering. Streaking is algae (Glossy black stain, common in Glendale) and doesn’t mean the shingle is gone. Blistering – small raised bubbles in the surface – means moisture is trapped in the shingle mat. That one is structural and needs replacement.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

A targeted IKO roof repair in Glendale runs $400 to $1,800 installed. The low end covers replacing a handful of damaged shingles or resealing lifted tabs; the high end covers a valley repair, a flashing reset, or a section of underlayment and shingle over a few hundred square feet. A full IKO replacement in Glendale runs $8,000 to $20,000, driven almost entirely by the square footage of the roof, the pitch, how many layers are being torn off, and whether the decking needs repair underneath.
Tile roof repair – a separate line item if your IKO roof is partially tile – runs $600 to $2,500. Metal roof installation, if you’re considering moving off shingle entirely, runs $15,000 to $40,000.
The range is set by roof size, pitch, layer count, and decking condition. Every quote we write is a flat price with a written scope and a written warranty. No “call for a quote” – the number is on the page before anyone picks up a hammer. Under Clause 1 of the Haven Standard, additionally, no change proceeds without a signed change order. We’ve built 4,000-plus projects this way, and costs land within a few percent of the agreed number.
DIY or Call Us?
There are things you can safely check. From the ground with binoculars, look for curled tabs, visible splits, and dark streaks. From inside the attic with a flashlight, look for water stains on the ceiling joists or plywood. Pull out the gutter downspout screens and see how much grit they’re catching. That’s a safe inspection, and the information is useful.
Getting on a roof to replace IKO shingles is a different matter. Two-storey roof work, steep pitch, and ladder placement are where serious injuries happen, and a shingle job gone wrong – sealant strip installed upside down, nail zone missed, flashing lapped backward – fails within one rainy season and produces the kind of interior water damage that costs far more than the original repair. Glendale’s older sections and hillside homes with steep, complex pitch make this especially true. The honest advice: inspect from the ground and from the attic, and call a professional for the roof itself. We’re fully insured, and each crew members’ background is verified before they arrive.
Call us at (844) 320-5930 for a free estimate – the written number comes before any work starts, no exceptions.
FAQs

How long does IKO roofing last in Glendale? A modeled service life of 25 to 30 years for three-tab and 30 to 50 for architectural IKO shingles is typical, but real-world lifespan in Glendale often comes in shorter – usually 20 to 30 years – because of sun load and thermal cycling. Call (844) 320-5930 for an inspection; estimates are free.
Can IKO roofing be repaired instead of replaced? Yes, frequently. A curled tab, a local leak at a valley or penetration, or a handful of cracked shingles is a repair, not a replacement. Repairs also make sense when the shingle is under 15 years old and most of the surface is still intact. Call for a free estimate and we’ll tell you which one you actually need, not the more expensive one.
How long does an IKO shingle repair take? A spot repair – a few shingles, a reseal, a flash reset – is typically a few hours. A larger section or valley repair is a day. A full roof replacement is 2 to 5 days depending on size, pitch, and tear-off layers. Call (844) 320-5930 to get a schedule and a written quote.
How do you source IKO parts for my roof? We source through 50-plus vetted brands and can match the IKO series from a physical shingle sample or the bundle label. When the exact IKO product is discontinued, we match by tab size, thickness, color, and sealing strip position – the four specs that matter – rather than just color alone. Call (844) 320-5930 for a free estimate and a line-by-line sourcing explanation.
Will the price change once work starts? No – not without a signed change order first. Under Clause 1 of the Haven Standard, the written price is fixed, the scope is written, and no additional work proceeds without your signature. In practice, our projects finish within a few percent of the number you agreed to, and every visit leaves you with a documented photo record of what was found and what was done.
We back every job with the 365-Day Done Right Promise: if it’s not done right, we make it right. And if you already have a written estimate from another Glendale contractor, bring it in – the free second opinion is line-by-line, at no charge. Roofing is one of seven trades under Rowan Construction Group Glendale, alongside kitchen and bathroom remodeling, windows and doors, fence, driveway and pavers, and home additions including ADUs.
Call (844) 320-5930 for a free estimate on your IKO roof repair or replacement.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












