







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CertainTeed Kitchen Remodeling: The Glendale Owner’s Guide
Kitchen remodeling in Glendale with CertainTeed materials typically runs $14,000 to $45,000 installed, and most jobs are scheduled within a few days of a signed written quote. CertainTeed touches the parts of a kitchen you handle every day: the gypsum board behind the tile, the fiber cement backer that holds the backsplash, the insulation that keeps a south-facing wall from baking in July. When one of those layers fails, you usually find out through a symptom you can’t ignore. Tile pops loose and the grout line opens. A soft spot spreads behind the sink. The backsplash darkens at the bottom where water has been getting in through a seam for months. By the time a Glendale owner calls us, the failure is almost always visible at the surface and much bigger underneath.
Key takeaways:
- Installed kitchen remodel in Glendale: $14,000 – $45,000, quoted as a flat written price before work starts.
- CertainTeed board, backer and insulation are matched to the kitchen’s moisture and heat load, not picked off a shelf.
- Written price before any work, no change without a signed change order, and a documented photo record of what we found.
- We’re an independent contractor and not affiliated with CertainTeed; we source and install CertainTeed-compatible materials.
Which CertainTeed Kitchen Remodeling Materials This Applies To

CertainTeed doesn’t sell one “kitchen product.” The materials you’ll actually touch in a kitchen fall into three families, and each fails differently. The first is gypsum board, including moisture-resistant and mold-resistant board for the wall behind the sink, range and dishwasher. The second is fiber cement backer board, the substrate that carries tile on a backsplash or a wet wall. The third is insulation, both batt and blown, which decides how much heat a west-facing Glendale kitchen wall pushes back into the room through a 100°F afternoon.
Identifying the right replacement starts with the label. CertainTeed board carries the product name, thickness, and in the case of moisture-resistant board, a clear designation on the paper face and the bundle wrap. Thickness matters: 1/2-inch board is standard for walls, 5/8-inch is used where fire rating or stiffness is needed, and backer board comes in 1/4-inch for floors and 1/2-inch for walls. Measure before you order. A 5/8-inch board will not fit a reveal cut for 1/2-inch, and the mistake shows up only after the tile is set.
The OEM-versus-aftermarket question is real here. CertainTeed board is sold through lumber yards and building supply houses, and a quality equivalent from another manufacturer is often functionally the same for a standard interior wall. Where we don’t substitute is backer board on a wet wall or a shower-adjacent kitchen wall. The brand doesn’t matter as much as the spec: cement-based, correct thickness, fastened at the right spacing, with the seams taped and bedded. We name the spec in the written quote so you can check it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CertainTeed Kitchen Remodeling Materials Are Failing
- Tile or backsplash lifting off the wall. Backer board that got wet and swelled, or board installed without the correct fastening pattern, loses its grip on the thinset. Once a tile sounds hollow when tapped, the bond is already gone in that spot.
- A soft or spongy spot behind the sink or under the dishwasher. Moisture-resistant gypsum board is water-resistant, not waterproof. A slow supply-line drip or a dishwasher door that’s leaked for a season will soften the paper face and the core behind it.
- Dark staining or a musty smell at the base of a wall. Water tracking down behind the backsplash and pooling at the bottom plate. In Glendale’s older homes, this often shows where a previous remodel tied new board to an original wall with no proper moisture break.
- Visible cracks running along board seams. Seams that weren’t taped and bedded, or board butted tight against a corner with no gap for movement. Glendale’s summer heat cycling through exterior walls makes an untaped seam open within a season or two.
- A kitchen that won’t cool on the west or south wall. Insulation that was compressed, skipped, or soaked during an earlier leak. Compressed batt loses a meaningful share of its R-value, and the wall behind the cabinets is the one nobody checks.
Two things we see repeatedly in Glendale specifically. First, homes built in the 1920s through 1950s around Adams Hill and Somerset often have original plaster over wood lath, and a prior remodel glued new board directly over it. That sandwich traps moisture, and the CertainTeed board fails from behind. Second, kitchens with a wall shared with an unconditioned garage or a sun-baked exterior get a much heavier heat and moisture load than a standard interior wall, and board spec’d for an interior partition won’t hold up there.
Replacement Cost & What’s Included in Glendale

Here’s what Glendale homeowners actually pay for kitchen work that involves replacing CertainTeed board, backer or insulation, quoted as a flat written price before anything is torn out:
| Scope | Installed price range |
|---|---|
| Small kitchen remodel | $9,000 – $20,000 |
| Full kitchen remodel | $14,000 – $45,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
The range is driven by three things: how much board and backer has to come out, whether the wall behind it needs framing repair, and whether the job is a targeted replacement or a full remodel. Parts and labor are broken out on the quote. A moisture-damaged wall behind a sink is a board-and-backer job; a kitchen where the backer failed under the tile across the whole run is a larger scope, and we tell you which one you have before we quote. Under Clause 1 of the Haven Standard, the price is written before anyone starts, and no change proceeds without a signed change order. Work carries our 365-Day Done Right Promise, printed on the quote and backed by a written warranty.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some checks are safe and useful. You can tap along the backsplash and listen for hollow spots, look under the sink for staining on the board, check for softness with light finger pressure, and pull a receptacle cover to see whether the board behind it is dry and intact. Take photos of what you find. That’s the information a contractor needs to give you an honest number.
Where it goes wrong: cutting out and replacing board behind a live kitchen wall means shutting off circuits, cutting around plumbing, and matching thickness and fastening so the tile sits flat. Backer board on a wet wall has to be taped, bedded and fastened to a specific pattern, or the tile fails again in a year. And if there’s any chance the wall contains old electrical or a gas line, that’s not a homeowner job. If you find soft board, cracked seams or a musty smell, call (844) 320-5930. Estimates are free, and we’ll tell you what we found in plain terms, with photos.
FAQs

Properly installed and kept dry, moisture-resistant board and fiber cement backer should last the life of the kitchen, 30 years or more. What shortens that in Glendale is water, not age: a slow leak, a failed seal at a sink or dishwasher, or board glued over old plaster with no moisture break. If we find a leak source, we fix it before new board goes in. Call (844) 320-5930 for a free estimate.
Often yes. A localized soft spot behind a sink or a short run of failed backer can be cut out and patched, provided the surrounding board is sound and the leak is fixed first. Whether a patch holds depends on where the failure stops; we check the whole wall before quoting a patch, because a repair over a spreading problem fails again. Call (844) 320-5930 and we’ll tell you which one you have.
A targeted board or backer replacement is usually a one- to three-day job; a full kitchen remodel that includes new board, backer and insulation runs several weeks depending on cabinet and countertop lead times. We give you the timeline in the written quote, not as a verbal estimate. Call (844) 320-5930 for a free estimate with a date range.
We source CertainTeed-compatible board, backer and insulation through building supply houses and match product, thickness and spec to your kitchen’s walls and moisture load. We’re an independent contractor, not affiliated with CertainTeed, and we name the exact spec on the written quote so you can verify it. For cabinets, countertops and fixtures we also work with KraftMaid, Cambria and Silestone, among others. Call (844) 320-5930 to schedule your free estimate.
Get a Written Price for Your Glendale Kitchen
If you’ve found soft board, lifting tile or a musty wall in your Glendale kitchen, the next step is a written number, not a sales visit. Call Rowan Construction Group Glendale at (844) 320-5930 to schedule your free estimate. We’ll document what we find with photos, quote a flat written price with the scope spelled out, and back the work with our 365-Day Done Right Promise. Bring a competitor’s estimate if you have one; our free second opinion reviews it line by line at no charge. Our technicians have up to 19 years of experience, and a live person answers the phone when you call.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












