







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sterling Driveway & Pavers: The Glendale Owner’s Guide
We install and repair Sterling-compatible driveway and paver systems in Glendale, and the honest installed number runs $7,000 – $18,000 for a paver driveway, $4,500 – $12,000 for concrete, and $250 – $700 for sealing. Sterling is a real material line, not a single part, so “my Sterling driveway failed” almost always means one of four things: a paver that shifted or cracked, a failed polymeric joint, a settled base under the slab, or a sealing coat that wore through. Most Glendale owners find it the same way. A paver rocks underfoot after a rain, a hairline crack walks across three or four units, or the joints start spitting sand into the gutter every time the hose runs.
Which Sterling Models This Applies To

Sterling paver lines are sold by profile and by thickness, and both matter. Standard driveway pavers sit at 60mm or 80mm; 60mm belongs on a patio or walkway, and putting it on a driveway with vehicle loads is the single most common compatibility mistake we see in Glendale. Measure the thickness of a loose unit with a tape before you order anything. Profile width and length vary by series too, so a replacement paver from a different Sterling run won’t key into your existing pattern cleanly.
Identifying the right match means three checks. First, the stamp or impression on the underside or side of a paver, which often carries the series name. Second, thickness in millimeters. Third, color and surface texture, because dye lots shift between production runs and a five-year-old faded paver will not match a fresh one out of the wrapper. Sketch the pattern and count the units you need before you call anyone.
On the OEM-versus-aftermarket question, we’re straight with Glendale homeowners: for pavers, a quality aftermarket unit of the same thickness and a close color match performs identically, and it’s usually cheaper. For the base and joint materials we specify real products by name, including Belgard and Techo-Bloc, rather than generics. Rowan Construction Group Glendale is an independent service provider and is not affiliated with Sterling.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sterling Driveway & Pavers Is Failing
Each of these points to a specific cause, and the cause decides the fix.
- Pavers rocking or dipping underfoot. The bedding sand has washed out or the base wasn’t compacted to depth when it was laid. Fixing the surface without fixing the base buys you one wet season.
- Joint sand washing out after rain. Polymeric joint sand has broken down or was installed in wet conditions. In Glendale’s dry stretches followed by hard winter rain, a failed joint opens fast and lets water into the base.
- Hairline cracks crossing multiple pavers in a line. This is usually a base failure or root heave underneath, not bad pavers. A single cracked unit is impact damage; a crack that jumps three units is structural.
- Sunken or heaved slab sections on a concrete driveway. Soil movement and poor drainage at the apron. Glendale’s clay-heavy soils expand and contract with our wet-dry cycle, and an apron that ponds water will always fail first.
- Sealer peeling or turning chalky. A sealer applied over a damp or dirty surface, or one past its service life. It looks cosmetic and isn’t – a failed sealer lets water into the joints and hastens everything above.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

The range depends on square footage, base condition, access, and whether we’re resetting existing pavers or replacing them outright. Here’s what Glendale homeowners actually pay:
| Work | Installed Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
The low end assumes a sound base and good access; the high end means excavation, new base, and drainage work. Under the Haven Standard, you get a flat written price with a written scope before anyone picks up a tool, and no change proceeds without a signed change order. The 365-Day Done Right Promise backs the work: if it’s not done right, we make it right.
DIY or Call Us?
Some things you can safely check yourself. Measure paver thickness. Look for the series stamp. Note where water ponds. Photograph the failing area with a ruler in frame so you have a record. That much is useful and costs nothing.
Where it goes wrong is the base. Resetting a few pavers over a bed that wasn’t compacted properly, or sealing over a damp joint, is a weekend of work that fails in one rain. Slab replacement and anything involving a saw, excavation, or vehicle-load structural work is not a homeowner job, and we’ll say so plainly. Send us a photo and we’ll tell you what we can see. Call (844) 320-5930 to schedule a free estimate.
FAQs

How long does a Sterling paver driveway last in Glendale? Fifteen to twenty-five years with a properly compacted base and resealing every three to five years, though Glendale’s dry-then-wet winters wear joints faster than the pavers themselves. Call (844) 320-5930 for an exact quote – estimates are free.
Can it be repaired instead of replaced? Often yes. Resetting, re-sanding, and resealing a failing section costs a fraction of a full replacement, and we’ll tell you honestly when repair will hold and when it won’t. A written price before work starts is standard here.
How long does the job take? Sealing is a single day. Resetting a section runs one to two days. A full paver driveway typically takes three to five days including base prep and cure time. Call (844) 320-5930 and we’ll give you a written timeline with the price.
How do you handle the part and the material? We match the Sterling profile and thickness by measurement and stamp, source from fifty-plus vetted brands including Belgard and Techo-Bloc, and put the flat price in writing before any work begins. Bring a competitor’s estimate and we’ll review it line by line at no charge.
If you have a failing Sterling driveway or paver system in Glendale, call (844) 320-5930 for a free estimate. You’ll get a flat written price and a documented photo record of what we found, every time. We also service KraftMaid, Cambria, and Silestone products on other trades.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












