







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sakrete Home Additions & ADU: The Glendale Owner’s Guide
Sakrete is a bagged concrete, mortar and repair-mix line, not a manufacturer of additions or ADUs themselves. When we say “Sakrete home additions & ADU in Glendale,” we mean the structural concrete work that carries an addition or detached unit: slabs, footings, stem walls, piers and the patching mixes that tie them together. A typical home addition in Glendale runs $45,000 – $130,000 installed, and an ADU runs $90,000 – $220,000. This is planned construction, not emergency work, so we quote a written price before anyone picks up a trowel.
Owners usually discover a concrete failure the same way. A hairline crack in the stem wall widens through a wet season and starts weeping. A slab edge under a new doorway crumbles when a jamb is cut. A footing that was poured over a soft, unconsolidated base settles and the new wall above shows a stair-step crack in the stucco. In Glendale, the pattern we see most often is a slab or patch that was mixed and placed during a warm, dry afternoon with no curing control, then hit by the first rains. The failure shows up two seasons later, when the adjacent framing has already been finished around it.
Key Takeaways
- Sakrete supplies mixes, not additions. The part that matters is the structural concrete the unit stands on.
- Installed addition cost in Glendale: $45,000 – $130,000. Detached ADU: $90,000 – $220,000.
- Most failures trace to base preparation and curing control, not to the bag of mix.
- We’re an independent contractor, not affiliated with Sakrete. We’re also not the brand.
Which Sakrete Models This Applies To

Sakrete’s lineup breaks into three families you’ll actually see on an addition or ADU job in Glendale. First, high-strength concrete mixes (often sold as Crack-Resistant or High-Strength Concrete Mix) for slabs, footings and piers. Second, mortar and sand mixes for block, brick and stem-wall coursing. Third, patching and repair products for spalls, cracks and leveling. Each family carries its own printed bag weight, yield, and compressive-strength figure at 28 days. Read the bag, not the shelf tag; a 60 lb versus 80 lb bag of the same family yields differently, and yield is what tells you how many bags a given pour needs.
The identification job is the easy part. Every Sakrete bag prints the mix family, the bag weight and the strength rating, usually with a coverage table in square or cubic feet. Match that printed family to the spec the engineer drew for the addition: a footing spec calls for a specific mix strength, and a bag that reads “general purpose” is a different animal than one rated for structural footings. On the OEM-versus-aftermarket question, Sakrete is already a national brand stocked widely, so there’s no dealer-only OEM premium to chase. Good-quality aftermarket equivalents exist and are fine when the printed strength rating matches the spec. What we won’t do is substitute a weaker family to save a few dollars on a pour that a two-story addition will sit on top of.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sakrete Home Additions & ADU Is Failing
Concrete failures announce themselves slowly. Here’s what we look for when a Glendale owner calls us about a cracking slab or a settling addition:
- Hairline cracks that widen season to season. Shrinkage cracks are normal and stable; a crack that grows each wet season points to base movement or a pour that cured too fast.
- A slab that sounds hollow or drums when tapped. The mix has separated from the base underneath, usually because the subgrade wasn’t compacted before the pour.
- Efflorescence, a white chalky bloom on the stem wall. Moisture is migrating through the concrete and evaporating at the surface, a sign of rising damp or a missing moisture barrier under the slab.
- Spalling at slab edges and doorways. The top layer is flaking off, often from an early freeze thaw cycle or a patching mix that didn’t bond to the parent concrete.
- Stair-step cracks in the stucco above a new opening. The framing has moved because the footing below settled, and the finish is telling you before the structure does.
Any one of these on a completed addition deserves a look. If two appear together near a load-bearing wall, get eyes on it before the next season.
Replacement Cost & What’s Included

In Glendale, the concrete work inside a home addition or ADU is priced as part of the project, not as a standalone swap. A full addition runs $45,000 – $130,000. A detached ADU runs $90,000 – $220,000, and a garage conversion (often the cheapest route to a legal unit) runs $30,000 – $80,000. Within those ranges, what drives the number is excavation and base prep, formwork, reinforcement, the concrete volume itself, and curing control on the site.
Our written quote separates the concrete scope from the framing, finish and MEP so you can see exactly what the Sakrete-family mixes are costing versus labor. Parts and labor are itemized, the flat price is set before work starts, and no change proceeds without a signed change order. The finished work carries our 365-Day Done Right Promise, and every visit includes a documented photo record you keep.
Glendale addition and ADU pricing at a glance
| Scope | Installed range |
|---|---|
| Home addition | $45,000 – $130,000 |
| Detached ADU | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
There’s a real split here. An owner can safely check a few things: inspect for cracks and note their width with a pencil mark and date, tap the slab to listen for hollows, look for the white chalky bloom of efflorescence, and check that downspouts and grading send water away from the slab. That’s observation, and it’s useful.
Where DIY goes wrong: mix-your-own structural concrete for a footing or slab that carries an addition. The failure mode isn’t usually the bag. It’s base preparation, reinforcement placement and curing control, and a homeowner doing this alone for the first time on a large pour can get the base wrong and never know until the wall above it cracks. On anything load-bearing, get a trained set of eyes and a documented pour. Call (844) 320-5930 and we’ll walk the slab with you at no charge.
FAQs

Properly placed and cured structural concrete typically lasts 50-plus years, and in Glendale’s mild, dry climate, well-prepared footings and slabs routinely outlive the structure sitting on them. The lifespan shortens fast when base prep or curing control is skipped; those failures show up in two to five years, not fifty.
Often yes, if the failure is a spall, crack or localized patch and the base beneath is intact. A settling footing or a slab that has separated from its subgrade usually needs underpinning or replacement, since patching over a moving base is temporary. We diagnose which situation you have before quoting. Call (844) 320-5930 for a free second opinion on any estimate you already have.
The pour itself is often a single day, but the full concrete scope on an addition (excavation, base prep, forms, reinforcement, the pour, and curing) typically takes one to three weeks, depending on size and inspection schedule. The curing period before framing starts is non-negotiable; rushing it is how hairline cracks turn into structural problems.
We source Sakrete-family mixes through established building-supply distributors in the Glendale area, matching the family and printed strength rating to the engineer’s spec, and we verify the yield and batch before the pour. If a spec calls for a strength that the stocked families don’t meet, we specify an appropriate mix rather than substituting down. Our technicians have up to 19 years of experience, and the mix selection is documented in the photo record.
We also work with KraftMaid, Cambria and Silestone on the finish side of an addition or ADU, so the same project that starts in concrete can carry through to cabinetry and counters under one written scope.
Get a Written Price for Your Glendale Addition
If you’re planning an addition, an ADU, or a garage conversion in Glendale, the number you want is on paper before anyone breaks ground. Under Clause 1 of The Haven Standard, your quote is a flat price with a written scope and a written warranty, itemized so you can see the concrete, the labor and the finishes separately. Rowan Construction Group Glendale is an independent contractor, not affiliated with Sakrete. Call (844) 320-5930 for a free estimate, and bring any written estimate you already have for a free line-by-line second opinion.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












