







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Home Additions & ADU: The Glendale Owner’s Guide
A Quikrete-based addition or ADU in Glendale typically lands between $45,000 and $130,000 installed for a home addition and $90,000 to $220,000 for a full ADU, and kitchen, bath, or garage-conversion scopes inside that envelope start lower. We’ll be precise about what that money buys, what the Quikrete formulation actually covers, and where Glendale’s soil and permitting realities change the plan. Owners usually start calling after a quote from another contractor reads thin on the concrete side, or after a structural engineer flags a foundation spec that won’t hold.
Key Takeaways
- Quikrete is a cement and concrete materials brand, not a parts manufacturer for additions. What we’re matching is the concrete mix spec to your project’s slab, footing, or stem wall.
- Glendale sits on a mix of alluvial soil and hillside clay, and the wrong Quikrete blend will show hairline cracking within the first two winters.
- The written price comes before anyone touches a tool. Under Clause 1, that’s not a courtesy, it’s the contract.
- Quikrete-specific concrete work is not a DIY job on any load-bearing scope, and we’ll say so plainly below.
Which Quikrete Projects This Applies To

Quikrete’s product line covers a real range, and the match matters more than the logo on the bag. For a footing pour under a Glendale addition, you’re looking at Quikrete 5000 or a high-strength concrete mix rated above 4,000 psi. For an ADU slab on grade, Quikrete Concrete Mix (No. 1101) is the common field spec, and for post-setting and stem wall work, Quikrete Fast-Setting Concrete gets used when the schedule compresses. The exact bag number matters less than the psi rating and the aggregate ratio, which the engineer’s plans will call out, and which any honest bid should match line by line.
To identify what your project needs, the label on the existing mix bag is the wrong place to look. The plans, the inspector’s corrections, and the structural engineer’s spec sheet are what drive the Quikrete blend selection. If you’re not sure which series applies, the fast-setting versus regular concrete distinction comes down to cure time and load requirements, not brand. Fork out a few dollars more for the higher-psi Quikrete product and you’ll thank yourself in ten years. The OEM-versus-aftermarket question doesn’t really exist for cement, but for the fixtures and cabinetry that go inside the addition, prices range widely. KraftMaid, Cambria, and Silestone come up often on Glendale additions, and we source all of them.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Foundation or Slab Is Failing
- Hairline cracks that widen each winter. Glendale’s clay-heavy soil expands and contracts with our two-season climate, so a crack that jumps from 1mm to 4mm in a year points to an underspec’d mix or missing drainage.
- White powdery deposits on the slab edge. Efflorescence is moisture wicking through a porous Quikrete pour, usually from a missing vapor barrier or an exterior grade that pools water against the foundation.
- Door frames that won’t close the same way twice. This is differential settling, and in a Glendale hillside build it’s the earliest signal the footing didn’t hit stable soil.
- Visible exposed aggregate on the slab face. That means the Quikrete mix was too dry at pour or the finishing window was missed, and surface integrity is compromised.
- Interior flooring lifting at the perimeter. A slab edge curling against the wall is a curing problem, usually from a fast-setting mix applied without proper moisture control in the heat.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included for Glendale Homeowners

Here’s what written prices look like for Glendale addition and ADU scopes:
- Home Addition: $45,000-$130,000. Quikrete concreting work (slab, footings, stem wall) accounts for roughly 8-15% of that, or $4,000-$19,000 depending on square footage and soil corrections.
- ADU Construction: $90,000-$220,000. Full Quikrete foundation scope typically runs $10,000-$28,000, and structural engineer’s specs drive the number.
- Garage Conversion: $30,000-$80,000. Often the cheapest path to an ADU permit in Glendale, and the existing slab sometimes means the Quikrete work is minimal.
What drives the range: soil corrections in hillside Glendale, the inspector’s footing depth requirements, drainage engineering, and the complexity of tie-ins to an existing structure. The price we write is a flat number with a written scope attached.
DIY or Call Us?
You can safely inspect an existing slab, photograph cracks with a tape measure for scale, note where water pools against the foundation, and feel for soft spots. What you should not do is pour structural Quikrete concrete, frame or shutter a footing, or set a stem wall against a load-bearing addition. Concrete work looks simple and goes wrong in ways that cost two to three times the original job to correct. Glendale’s building department will fail a DIY pour that doesn’t meet the lateral and uplift requirements in the plans, and the fix is demolition plus re-pour, not repair.
Call (844) 320-5930 and we’ll walk through what you’re looking at. Free second opinion on any written estimate you already have, line by line, no charge. The crew comes background-checked and uniformed, and every visit includes a documented photo record.
FAQs

Properly specc’d Quikrete concrete in Glendale lasts 50+ years with a functioning moisture barrier and drainage. The variable is soil movement, not the concrete. A hillside pour without a drainage plan can show failure signs in 5-7 years.
Sometimes. Hairline cracks under 2mm with no displacement can be sealed and monitored. Cracks with vertical separation, efflorescence, or perimeter curling usually mean the slab is compromised, and repair is a stopgap.
The Quikrete concreting portion runs 3-5 days for a standard ADU slab and up to 10 days for a hillside footing with corrections. That’s before cure time, which is 7 days minimum before framing loads it.
Quikrete is stocked locally across Glendale suppliers, so we spec the exact bag and psi rating on the plans and pull from the supplier that has it in quantity for the pour day. No substitutions without an inspector and engineer sign-off.
Glendale additions and ADUs are a Quikrete-driven concrete project first and a design project second, and the foundation is the part nobody redoes later without pain. Rowan Construction Group Glendale writes the price before the pour, stays within a few percent of the agreed number across the job, and backs it with the 365-Day Done Right Promise. Call (844) 320-5930 to schedule a free estimate and get the concrete spec, the Glendale permit path, and the line-item number in writing. Quikrete is a registered trademark of its owner; Rowan Construction Group Glendale is an independent contractor and not affiliated with Quikrete.
Written by the team at Rowan Construction Group Glendale, serving Glendale and nearby areas.












